Why is my shower leaks -, what do

Why is my shower leaks, what to do. Have you ever had a shower pan was not sealed? This can be a homeowners nightmare! This may be the walls and floors, resulting in mold and fungus can ruin a health risk.

Some background information:

Some of the old house built 20 years ago or more the "structure" shower trays. They are a kind of tar paper. When filled with water from a leaking shower baseBrick work in cement, wet shower pan, over time, deteriorate, the pan is no longer held against leakage receptors. Water just ran out of the ground floor in the bathroom.

To use the new bathroom shower pan vinyl material, does not worsen. Therefore, unless there is a serious loophole in the vinyl construction nails or screws pot pot, it retained the leakage of water from the shower task layersFlood the bathroom. Therefore, the new vinyl pan, or if you have copper solder pot, you must maintain a large receptor leaks.

But ... even with a good shower pan, you can still have problems: If the cement in the shower pan is completely saturated with water, no place to go only through the wall, next to the bathroom capillary. If you cementatious sub-wall, this is not a bad thing, if the correct and timely. The wall is dryA loose tile or marble, can be replaced.
If you put a green on the walls of the board of directors (walls), if not in the red and set the next, the last fundamental changes.

Why leave the shower?

For the shower floor leak is a mistake to install the most common reasons:

1. What is not reduce the wall tiles or marble.

2. In the. The water in the depression, rather than cement block aspects of the work flow of low-loss region. Some Materials can migrate into the pot.

3. Cut brick itself may not be able to determine leakage cracks, and open water entrance.

4. One of the most common reason is to speak a shower after the installation of the wall!
In this case, if the shower will change the expansion and contraction causes temperature changes, or estimate the house. A crack or separation between the shower walls and floors finished complete shower. "This is the input "Water."
Shower floor should be established to the contrary, is a country in the shower wall material of the finished floor, forming a water barrier, and its a lot of difficulties in inches of water there is a hole in the second series in a stream of water to happen, if the concrete floor Under the top of the wet, but my experience is rarely productive.

5. Sometimes Do not let the shower water at the bottom, it is"Transitional behind the wall leaks. It's easy determine.Take from the tap handle eschucheon (cover) the handling of the square and open water. To find that hole with a flashlight, if necessary, take a look at the invasion of water from the conversion, once the In a period of time, this is the problem. If you need a new divereter.

More next article: How do you shower to prevent leaks and prevention ofMaintenance